Zum Hauptinhalt springen
Internal notes
TitleConfigure Master-Slave
Statusdraft ✏
Sources
Preview Link...
Version: 5.32

Configure Master-Slave

Goal​

Configure two Charge Controllers to operate in Master-Slave mode, allowing to operate two charge ports in a single Charging Station.

Before you begin​

Make sure that

  • Both Charge Controllers have the same controller firmware version
  • Both Charge Controllers have the modern Dashboard set as the default. See here (coming soon).

Steps​

Configuring the Master Charge Controller​

  1. Connect the Charge Controller that should be the Master to a computer with a micro USB cable through the CONFIG USB port.
  2. Open the PENDING and navigate to the Manufacturer section (http://192.168.123.123/legacy/manufacturer/manufacturer)
  3. Near the bottom of the page, for the Master/Slave Mode field, choose Master
  4. At the bottom of the window, click , then click to apply the changes

Configuring the Slave Charge Controller​

  1. Connect the Charge Controller that should be the Slave to a computer with a micro USB cable through the CONFIG USB port.
  2. Open the PENDING and navigate to the Manufacturer section (http://192.168.123.123/legacy/manufacturer/manufacturer)
  3. Near the bottom of the page, for the Master/Slave Mode field, choose Slave
  4. At the bottom of the window, click , then click to apply the changes

Connecting the Master and Slave​

Run a micro USB cable from the Master's Host USB port to the Slave's CONFIG USB port.

Accessing the Master and Slave Controllers​

Connect a computer with the Slave Charge Controller and Access the Master or Slave like so:

Master ControllerSlave Controller
http://192.168.123.123http://192.168.123.123:81